Battery Charger; Control Panel - Husqvarna LE 322R Manual De Usuario

LED on the battery
The error LED flash-
es.
The error LED is on.

Battery charger

LED on the bat-
tery charger
The error LED
flashes.
The error LED is
on.

Control panel

If you cannot find a solution to the problem,
speak to your Husqvarna service agent.
22
Cause
The battery is weak.
The temperature in the work en-
vironment is too high or too low.
Overvoltage.
The cell difference too much
(1V).
Cause
The temperature in the work
environment is too high or
too low.
Solution
Charge the battery. Refer to
battery on page 13 .
Use the battery in temperatures between
-10°C and 40°C.
Make sure that the mains voltage is the
same as on the rating plate on the product.
Remove the battery from the battery charg-
er. Wait 5 seconds and try again to charge
the battery. If the problem continues, speak
to an approved service agent.
Speak to an approved service agent.
Solution
Use the battery charger in temperatures between
5°C and 40°C.
Speak to an approved service agent.
To charge the
1840 - 004 - 18.10.2022