Operation Method - septodont SYG-200 Manual De Instrucciones

5. Operation method

1) As shown in Fig.1, turn the power switch on the rear side of the main unit to the "-"
position to turn on the power. At this time, the screen will display the initial working
time (40 seconds).
2) Choose fine capsules of silver with mercury.
3) Press the cap on the top of the capsule into the capsule, allowing the inner silver
powder and mercury to be in close contact.
4) Open the transparent protecting shield and fix the capsule onto the mixer's holder,
then close the cover, As shown in Fig.3.
5) Time set – Press the "
time.
6) Press the "START" key, the mixer starts running and stops at the end of the set time.
If you want to stop a running mixer, press the "START" key again.
7) When the mixer has stopped, you can open the cover and retrieve the mixed capsule
that can now be used.
8) After the work is completed, please turn the power switch on the rear side of the
main unit to the "O" position to turn off the power.
In order to fully lubricate the transmission mechanism of the machine, it is

recommended that when the user first uses the machine every day, let the machine
run without load for 60 seconds first to make the machine reach the best working
condition.
6. Precautions, maintenance and disposal
1) Precautions
a) The main four red transport fixing screws on the bottom of the device must be
removed before first use.
b) Put the device on the flat desktop when in use, and maintain good ventilation.
c) Make sure that the power plug is firmly attached, and the power plug is easily
accessible.
Fig 3
" key to extend the time, press the "
- 4 -
" to decrease the