Troubleshooting And Repair - septodont SYG-200 Manual De Instrucciones

d) Please close the transparent protection shield before pressing the "Start" button to
running the amalgamator.
e) Please pay attention to rest the device to avoid overheating.
f) The device is non-AP-type equipment, and non-APG-type equipment.
g) Please be strictly in accordance with the operation instructions, such as violation
of normal operation which will cause damage to the equipment or operator injury.
h) Do not position the mixer so that it is difficult to operate the disconnection device.
i) Plug of the power adapter is used to isolate the ME equipment from the supply
mains.
j) Put the device on the flat desktop, and check the product labels and make sure
that the product is properly connected according to user manual.
k) When the mixer stops working, do not press the "start" button before the holder
completely stops swinging to avoid damage to the device structure.
2) Maintenance
a) Keep equipment appearance clean, the device enclosure and capsule holder can
be cleaned by alcohol, Cleaning operations should be carried out at the end of
every day.
b) If the device has not been used for a long time, please disconnect the power and
place it into the box for storage.
3) Disposal
a) The product must not be discarded in domestic household waste.
b) Should you wish to definitively dispose of the product, please comply with the
regulations which apply in your country.

7. Troubleshooting and repair

1) Troubleshooting
No.
a) The LCD has no numeric display
b) Too loud operating noises
Remark:

To prepare for the above operation, be sure to disconnect the power and unplug the
power cord.
2) The Device has been tested in compliance to the standard IEC 60601-1-2: 2014
Electromagnetic compatibility restrictions. But do not rule out potential weak
electromagnetic interference to other devices or receiving sensitive chance of
interference to other equipment, if the above problems occur, it is recommended
to correct the interference by the following measures.
a) Connect the device to an outlet of a receiver circuit different from the one used by the
sensitive equipment.
b) Increase the distance between the device and the receiver of sensitive equipment.
c) Restart the device.
Symptom
Check whether the power cord is loose.
Check if the screws under the bottom of
the device have been removed or not.
Please remove before first use.
- 5 -
Solution