Di4 Gyro Laser 2000 Manual De Instrucciones página 36

Switching modes
Standby mode
Power on , light always on, the robot just standby (purple light
means wifi didn't connect to servicer . Blue light means connected)
Dormant mode
Power on, light
Working mode
When the robot is working,
enters the cleaning mode
Operating procedures
Dormant mode——Standby mode——Working mode
Boot up
Long press the power switch for 3 seconds, it is in the on state, press the robot button or
the function mode button on the remote control to start working
Pause
The robot is in the cleaning state, press the main unit key
and then press this button to enter the random cleaning mode
Dormant
The robot is in a pause state, and the button indicator does not light up
If you don't operate the machine for a short time, it will enter the sleep state, press the remote
control button to wake up the machine
close, the robot just stand by
the light is always on and the robot
or remote control button to pause work,
Water tank usage
When charging, please remove the water tank to avoid danger.
Water Tank Assembly:
There is corresponding velcro under the tank,fix the absorbent mop to the bottom of the
water tank according to the corresponding part,open the tank sealing cap,fill it with 1/2 or
2/3 clean water,and seal the lid of the water tank.
When charging, please remove the water tank to avoid danger.
Tank Installation
Hang the water tank component on the bottom of the Main Body according to the direction
like the picture. Fix the two columns of the water tank into the two holes of the Main Body
so that the water tank component combine with Main Body tightly.