Carga Automática - Di4 Gyro Laser 2000 Manual De Instrucciones

INSTRUCCIONES DE USO
Colocación de la base de carga
Coloque la base de carga contra la pared, dejando una distancia de seguridad a la izquierda y a la
derecha de 1 metro y de 2 metros por delante. Advertencia: no la coloque cerca de un espejo, evite la
luz solar directa.
Carga
Coloque la unidad principal en el soporte de carga para cargar el robot, y preste atención a la tecla de
la pieza de contacto de carga que parpadea, ya que indica que se está cargando. La luz
encendida o apagada significa que la carga ha terminado.
Carga automática
Pls press button , robot will start auto charging
When the cleaning is finished or the power is too low, the robot will automatically
start looking for the charging stand to charge.
Please keep the charging stand powered on, otherwise, the machine will not be able
Notes on charging
A. When the battery is low, light always on
B. When the robot is charging, the light
C. After fully charged, light always on
D. Please check the charging status of the robot after the power runs out
E. When charging for the first time, please make sure the robot is charged for at least 12 hours
F. If you do not use the robot for a long time, please turn off the machine
G. Please place the machine on the charging base during daily use and make sure the charging
base is connected to the power supply
H. When the battery is low, the robot will find the charging base for charging. Please make sure
that there are no obstacles around the charging base
flashes