Klarstein CTR-1 HEAT Manual De Instrucciones página 21

LEFT/RIGHT
TIMER
MODE
COOL button (cooling)
Note: If there is no or too little water in the tank, the COOL indicator light
flashes when you press the COOL button.
Before operating the unit in cooling mode, make sure that the outlet valve of the
water tank is firmly closed. Pour fresh water into the water tank Observe the water
level indicator when filling and make sure that you do not underfill or overfill. After
you have filled in water, press the COOL button. The unit will start blowing cool air
into the room. At the same time, the COOL indicator light will come on. As soon as
you press the COOL button again, the function will stop and the indicator light will
go out.
If the air still does not seem cool enough after activating the COOL function, you
can add additional ice cubes directly into the tank through the tank cover. Make
sure that the water level does not exceed the MAX mark after inserting the ice
cubes, otherwise the device may be damaged.
If you want to use the ice box instead of additional ice cubes, place them directly in
the tank. You will get the best possible cooling if you put the ice box in the freezer
for 1-2 hours beforehand.
If you want to replace water or clean the tank, pull the tank out completely.
If you operate the unit in COOL mode, it will continue to run for 5 minutes after
switching off. During this time, the timer control light will flash.
Press the button to make the fan flaps swing left and
right. This distributes the cool air better in the room. The
corresponding indicator light will come on. Press the
button again to stop the fan flaps from swinging.
Press the button to set the timer. The timer can be set
between 1-15 hours. The corresponding indicator light
comes on.
The default setting is NORMAL. Press the button
repeatedly to select one of the following modes:
NORMAL > NATURAL > SLEEP MODE. The corresponding
indicator light for the mode will light up as long as the
mode is running.
EN
21