1 SAFETY PRECAUTIONS
1 Before connecting the dispenser to the power source,
check that the voltage shown on the rating plate matches your
electricity supply. Connect the dispenser to a single-phase
supply through a grounded outlet as required by current
regulations.
2 Do not use extension cords to connect the dispenser.
3 To avoid any risks, if the power cable is damaged, it must
be replaced by the manufacturer, by an authorized technician
or by a similarly qualified person.
4 The dispenser is not suitable for outdoor use.
5 The dispenser must be installed in the upright position.
6 Before cleaning, always disconnect the dispenser by
removing the plug from the outlet.
7 Always disconnect the dispenser before removing any of
the panels for cleaning or maintenance work.
8 Do not use a water jet to clean the dispenser.
9 This dispenser must not be operated by children.
10 Do not let children play with the dispenser.
11 This appliance must not be used by persons with reduced
physical, sensory or mental capabilities or with a lack of expe-
rience and knowledge unless they have supervision or have
been trained regarding the safe use of the appliance and
understand the risks involved.
12 Only persons who know and have practical experience of
the dispenser are permitted access to the inner components of
the dispenser, especially when dealing with issues regarding
safety and hygiene.
13 For the dispenser to operate correctly, ambient temperature
must be between 41 °F and 89 °F.
14 Use the dispenser to cool the indicated liquids only.
15 Do not introduce dangerous or toxic liquids to the
dispenser.
2 TECHNICAL CHARACTERISTICS
Transparent removable
bowls
Capacity of each bowl,
gal
approx.
Dimensions:
width
in
depth
in
height
in
Net weight, approx.
lb
Gross weight, approx.
lb
Hermetic compressor
Air-cooled condenser
Overload protector
Noise level lower than
70 dB (A)
IMPORTANT
Electrical characteristics: Read the data on the plate of
each individual dispenser. This is located at the bottom
of the front panel, behind the drip tray on the right. The
serial numbers of the devices (preceded by the symbol #)
are shown on the frame below. Always refer to the data
shown on the plate.
We reserve the right to amend this manual without notice.
3 INTRODCTION
Read this instruction booklet carefully in order to familiarize
yourself with all aspects of the dispenser.
Like all mechanical products, this machine will require cleaning
and maintenance. Good operation can also be affected by any
errors made by the operator during disassembly and cleaning.
For this reason, in the case of daily operations such as
disassembly, cleaning, sanitizing and reassembly, it is important
that the person using the dispenser is aware of the procedures
and can perform them without making errors.
The warranty for the SCBA and SCBF machines is as follows:
Five years on compressor; Three years on electrical board; Two
years on non-wear parts; One year labor.
3
S B C A & S C B F
#
1
2
3
1
1.5
1.5
1.5
2.5
7.8
15.6
23.6
7.8
18.9
18.9
18.9 18.9 18.9 18.9
24
24
24
27.9 27.9 27.9
55
90
125
55
25
44
60
27
2
3
2.5
2.5
15.6 23.6
99
134
48
64