Technical Data; Specified Conditions Of Use; Safety Instructions; Charge The Battery - Würth WLH 1.3 Traducción Del Manual De Instrucciones De Servicio Original

GB
RECHARGEABLE LED HAND LAMP
Art.
Number of LEDs:
Batteries
Supply voltage power supply unit
Frequency power supply unit
Supply voltage Luminaire
Power input Luminaire
Charging time
Lighting duration
LED light-Lifetime
Type of protection
Storage temperature
Operating temperature
For Your Safety
Please read and comply with these
operating instructions prior to initial
operation of your device. Keep
these operating instructions for later
use or for a subsequent owner.
Warning!
Risk of injury to the eyes
•
Do not look into the lamp when it is switched
on.
•
Make sure that no one is blinded.
Only use the charger recommended by the
manufacturer to charge the lamp. Use of a
charger that is NOT recommended may cause
a fire and destroy the lamp.
Prior to first use always read the safety
instructions! Failure to observe the operating
instructions and the safety instructions could
result in damage to the appliance and danger
for the operator and other persons.
Specified Conditions of
The lamp is used as intended if it is used exclu-
sively to illuminate ordinary work areas and if
the specifications stated in the technical data
are observed. Any other use or use beyond
this is not permitted.
The appliance must not be used,
•
in areas with harmful gases, oils, acids,
radiation, etc.
•
in potentially explosive atmospheres
This lamp complies with all relevant norms and
standards in connection with CE conformity. If
8

Technical Data

Use
WLH 1.3
0827 940 113
6
Lithium ion, 3,7 V, 1.100 mAh
100–240 V AC
50/60 Hz
5 V DC
850 mA
∼3 h
∼3,5 h
until 50.000 h
IP44
-20 °C ... +45 °C
-5 °C ... +40 °C
the lamp is modified, compliance with these
standards is no longer guaranteed.
It is forbidden to make any changes to the
device. Such changes can lead to personal
injury and malfunctions.

Safety instructions

Warning against hot
surfaces!
The lamp can become hot in the area
of light emission. Therefore, keep a
distance of at least
•
Do not cover the light emission.
•
Do not place the lamp with the light emission
pointing downwards.
•
Do not open the lamp.
•
There is a risk of a short circuit. Repairs to the
lamp may only be carried out by persons au-
thorised and trained for this purpose. Contact
your Würth branch.
A damaged lamp or charger may
no longer be used and may only be
replaced by the manufacturer.

Charge the battery

•
Charge before first use. Charging time:
6-8 h
•
Fully charge the fixture before storing it for
an extended period of time.
•
Switch off the light during charging.
•
Attach magnetic charging
•
Plug in the mains plug of the charger.
•
During the charging process, the LED of the
light switches to red.
•
The charging process is completed as soon
as the LED of the light switches to green
cable.