Technical Data; Charging Process - Würth 0827 981 501 Manual De Instrucciones

Technical data

Non-stationary
workplace lamp
Lamp luminous flux
Luminous flux of illuminant 5,300 lm
Colour temperature
Operating voltage
Capacity rating
Lamp's degree of protection IP54
Mains adapter's degree of
protection
Lamp's protection class
Mains adapter's protection
class
Impact protection rating
Lithium-ion batteries
Mains adapter line
Cable length
Earthed power outlet or
shaped plug
Charging temperature
range
Dimensions (H x W x D)
Weight approx.
Legend
Explanation of pictograms
Lamps with limited surface temperature
Dust-proof
Splash water-proof
Compliance with EU directives
Electronic scrap (WEEE directive)
Batteries are not household waste
Permitted in difficult conditions
Protection class II
Protection class III
Art.
0827 981 501
4,000 lm
5,000 K
220 – 240 V AC,
50/60 Hz
36 W
IP44
III
II
IK08
10.8 V DC, 2,500 mAh
H05RN-F2x1.0 mm² black
5 m
CEE 7/17 shaped plug
according to German/
Austrian and Belgian/
French standard
+5°C to +30 °C
320 x 300 x 125 mm
2,700 g

Charging process

Before taking the hand lamp into service for the
■
first time charge it for 6-8 hours.
Connect mains adapter to lamp.
■
3 Running light of the remaining running time
display starts when charging.
• Charging is complete as soon as the battery
capacity "100%" is displayed and all LEDs of
the remaining time display light up.
Characteristics
— Flashing of the 20% LED on the capacity dis-
play at a battery capacity of 10%.
— At a battery capacity of 10%, the lamp dims
automatically to the lowest brightness level
(5%). The luminous flux can be adjusted up-
wardly again using the +/- button.
— Remaining running time < 30 minutes: Every
5 minutes, the LED panel flashes twice.
— Remaining running time < 15 minutes: Every
minute, the LED panel flashes twice.
Note
With this lamp simultaneous
charging AND lighting is possible.
— The lamp has an integrated
overcharge protection and can
remain permanently connected to
the power supply.
Note
Fully charge the hand lamp before it is
stored for a longer period. Recharge
the lamp regularly if it is not used for a
longer period of time.
Note
Always keep the charging socket on
the lamp free of dirt! Use protective
cap!
7