MaxPro PROFESSIONAL MPBDP13 Manual De Instrucciones página 7

4) Power tool use and care
a) Do not force the power tool. Use the correct power tool for your applica
do the job be er and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be
controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the ba ery pack from the power tool before
making any adjustments, changing accessories, or storing power tools. Such preven ve safety measures
reduce the risk of st
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power
tool or these ins
users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any
other condi that may affect the power tool's opera
before use. Many accidents are caused by poorly maintained power tools.
f) Keep cu tools sharp and clean. Properly maintained cu
likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc. in accordance with these ins
account the working co
different from those intended could result in a hazardous situa
5) SERVICE
a) Have your power tool serviced by a qualified repair person using only iden cal replacement parts. This
will ensure that the safety of the power tool is maintained.
SAFETY INSTRUCTION FOR DRILL PRESS
Symbols
Danger Area! Keep hands far away from the cu
Keep bystanders away.
1) TOOL USE
DON'T FORCE TOOL
It will do the job be er and safer at the rate for which it was designed.
USE THE RIGHT TOOL
Don't force a small tool or a achment to do the job of a heavy duty tool. Don't used tool for purpose not
intended—for example, don't use a circular saw for cu
SECURE WORK
Use clamps or a vise to hold work. It's safer than using your hand and it frees both hands to operate the
tool.
NEVER LEAVE TOOL RUNNING UNATTENDED
Turn power off. Don't leave tool un
2) TOOL CARE
DO NOT ALTER OR MISUSE TOOL
These tools are precision built. Any altera
4
ower tool accidentally.
to operate the power tool. Power tools are dangerous in the hands of untrained
s and the work to be performed. Use of the power tool for opera
comes to a complete stop.
If damaged, have the power tool repaired
tools with sharp cu
rea while the machine is running.
ree limbs or logs.
or modifica not specified is misuse and may result in
GB
The correct power tool will
edges are less
taking into
s