Power Supply - IBEA OlivaRex E-5000 Manual De Usuario

Power on E5000 L - E5000 XL
Ref. g. C2
Use only 12V batteries. Do not use the machine with low batteries.
Ambient temperature: +1 ° C - +40 ° C.
Before making the electrical connections to the battery, proceed as follows:
• Connect the connector D, located at the end of the rod, to the ying connector E on the cable
S, then screw.
• Insert the ying connector F of the cable S into the housing G of the power supply 4.
• Connect the poles of the 12V battery to the power supply B using the pliers: red plier on the
positive pole (+) and black plier on the negative pole (-).
• The battery, not supplied, must never be connected to a battery charger during use.
• By keeping button N pressed for 1 second, the machine starts working.
Power on E5000 BPL - E5000 BPXL
Ref. g. C3
Before making the electrical connections to the battery, proceed as follows:
• Connect the connector D, located at the end of the rod, to the ying connector E on the S
cable.
• Insert the ying connector F of the cable S into the housing G of the battery 5.
• Turn on the battery using the switch J.
• The battery must never be connected to a battery charger during use.
• By keeping button N pressed for 1 second, the machine starts working.
This machine must only be connected to an original IBEA battery.
Characteristics of the IBEA battery: nominal voltage 36V - Capacity 20Ah.
Ambient temperature: +1 ° C - +40 ° C.
Power supply E5000 L - E5000 XL
The machine is powered by an accumulator - battery 12V - 50 ÷ 60 Ah (not supplied) which,
through a 0.5 m long bipolar cable with battery clamps, transfers current to the electronic
control board contained the power supply. The circuit regulates the supply voltage; in this way
it is possible to keep the motor rotation speed constant. The ashing red LED on the handle
indicates that the 12V battery has a residual charge of about 10%. The steady red led indicates
that the battery has run out of charge and, consequently, the machine stops.
Power supply E5000 BPL - E5000 BPXL
The power to the machine is supplied by a lithium battery with a nominal voltage of 36V and
20 Ah (placed in the backpack of the machine) which, through a bipolar cable, transfers current
to the electronic control board contained in the handle. Always press the button whenever you
want to stop the machine or unplug a cable. The ashing red LED on the handle indicates that
the 36V battery has a residual charge of about 10%. The steady red led indicates that the
battery has run out of charge and, consequently, the machine stops.
34