Before Use - Taurus BRISA 10 Manual De Instrucciones

for industrial or professional use. It is not intended to
be used by guests in hospitality environments such
as bed and breakfast, hotels, motels, and other types
of residential environments, even in farmhouses,
areas of the kitchen staff in shops, offices and other
work environments.
2.2.4. This appliance is not intended for use by
persons (including children) with reduced physical,
sensory, or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
2.2.5. This appliance is not a toy. Children should be
supervised to ensure that they do not play with the
appliance.
2.3. Use and care:
2.3.1. Fully unroll the appliance's power cable before
each use.
2.3.2. Do not use the appliance if the parts or
accessories are not properly fitted.
2.3.3. Do not turn the appliance over while it is in
use or connected to the mains power supply.
2.3.4. Unplug the appliance from the mains power
supply when not in use and before undertaking any
cleaning task.
2.3.5. This appliance should be stored out of reach
of children.
2.3.6. Do not store the appliance if it is still hot.
2.3.7. Never leave the appliance unattended when in
use and keep out of the reach of children.
2.3.8.If for some reason, the appliance were to catch
fire, disconnect the appliance from the mains power
supply and DO NOT USE WATER TO PUT THE FIRE
OUT.
2.4. Service:
2.4.1. Make sure that the appliance is serviced only
by suitably qualified technician, and that only original
spare parts or accessories are used to replace
existing parts/accessories.
2.4.2. If the power cord is damaged, the
manufacturer or its service agent or a similarly
qualified person must replace it in order to avoid a
hazard.
2.4.3. Any misuse or failure to follow the
instructions for use renders the guarantee and the
manufacturer's liability null and void.
3. Instructions for use

3.1. Before use:

3.1.1. Remove the appliance's protective film (if
applicable).
3.1.2. Before using the product for the first time,
clean in the manner described in the cleaning
944110_IM.indd 3 944110_IM.indd 3
section.
3.2. Assembly:
3.2.1. Tripod Leg Assembly
3.2.1.1. Take out the securing bolts and nuts.
3.2.1.2. Attach the metal part of the wooden tripod
leg to the tripod holder (Fig. 1), line up the holes and
fit the securing screws all the way through (Fig 2).
Take note of the orientation of the leg end.
Fig 1.
Fig 2.
3.2.1.3. Fit the nut to the protruding end of the screw
and tighten the nut.
3.2.1.4. Repeat steps 3.2.1.1 to 3.2.1.3 for the other
2 legs.
3.2.1.5. Open the legs to connect the three metal link
pipes using the wingnut. Shown in Fig. 3.
Fig 3.
3.2.1.6. Place the first washer on the wingnut screw
and thread through the holes in the 3 metal link
pipes.
3.2.1.7. Place the second washer on threaded screw
and tighten.
3.2.1.8. Adjust to your desired height using the
fastening knob and telescopic pipe.
3.2.2. The whole assembly:
3.2.2.1. Remove the locking knob from the pipe
beneath the U-holder as shown in Fig.4.
2021/06/08 08:56 2021/06/08 08:56