Publicidad
Step 8
å
Fasten one SIDE MOLDING (G) to one END (A). Use two SILVER 1-1/8"
FLAT HEAD SCREWS (10S).
å
NOTE: Be sure to position the SIDE MOLDING exactly as shown.
å
NOTE: Do not overtighten the SCREWS into the MOLDING.
www.sauder.com/service
x2
A
The hole is closer
to this edge.
427044
10S
SILVER 1-1/8" FLAT HEAD SCREW
(4 used in this step)
The MOLDING
will overhang the
edge of the END.
G
Page 13
Publicidad
