Publicidad
Step 15
å
Open the FURNITURE TIPPING RESTRAINT KIT (97) and fasten the
SAFETY STRAP to the UPRIGHT (L). Use the short screw provided.
å
NOTE: Position the SAFETY STRAP exactly as shown.
å
Fasten two SIDE MOLDINGS (G) to the ENDS (A). Use four SILVER
1-1/8" FLAT HEAD SCREWS (10S).
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
The hole is closer
to this edge.
G
SILVER 1-1/8" FLAT HEAD SCREW
(4 used for the MOLDINGS)
Page 20
A
10S
Safety strap
G
427044
L
A
These surfaces
should be even.
www.sauder.com/service
97
Publicidad
