Sauder 427044 Instrucciones De Montaje página 23

Step 18
å
Unfold the BACK (P) and lay it over your unit.
å
A perforation in the BACK (P) has been provided for access
to the SAFETY STRAP. Punch out the perforation and push
the SAFETY STRAP through the hole.
å
First, fasten the BACK (P) to the BOTTOM (C) and TOP
REAR MOLDING (K). Use four BLACK 9/16" LARGE
HEAD SCREWS (1S).
å
Second, finish fastening the BACK (P) to your unit using
the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
the UPRIGHT (L).
BLACK 9/16" LARGE HEAD SCREW
(4 used for the BOTTOM and MOLDING)
www.sauder.com/service
1
st
1S
C
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
K
P
These holes must line up
over the UPRIGHT (L).
427044
Caution
NAIL
(61 used for the BACK)
2
nd
Safety strap
Before fastening the
BACK, punch out the
perforation and push
the SAFETY STRAP
through the hole.
8
1N
Page 23