Sauder 426135 Instrucciones De Montaje página 18

Step 12
Turn six BLACK 9/16" FLAT HEAD SCREWS (32S) into the END (A) until the shoulders of the SCREWS rest on the surface
å
of the END.
NOTE: Do not overtighten the SCREWS.
å
Slide the MOLDING (K) onto the END (A). Line up the grooves in the MOLDING over the heads of the SCREWS in
å
the END.
NOTE: The MOLDING should be even on both edges of the END.
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Slide the MOLDING (L) onto the END (A) until it comes into contact with the MOLDING (K).
å
NOTE: If the MOLDING comes up off of the SCREWS, remove it and slide it on again.
å
Repeat this step for the remaining END.
å
L
BLACK 9/16" FLAT HEAD SCREW
Page 18
32S
(12 used in this step)
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
A
426135
K
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
www.sauder.com/service