Silver 1/4" Machine Screw - Sauder 426135 Instrucciones De Montaje

Step 24
Before fastening the DOOR to your unit, be sure the mounting screw is against the stops as shown in the right diagram. If
å
it isn't, loosen the adjusting screw and mounting screw to slide it against the stops. Then tighten the mounting screw.
Fasten the DOOR (R) to the END (A) as shown in the lower diagram. Use the screws in the HINGES. You should start each
å
SCREW a few turns before completely tightening any of them.
Fasten a PULL (22K) to the DOOR (R). Use a WASHER (10I) and a SILVER 1/4" MACHINE SCREW (61S).
å
Repeat this step for the other DOOR (R).
å
See the next step for DOOR adjustments.
å
Page 30
A
R

SILVER 1/4" MACHINE SCREW

(2 used in this step)
426135
17
Stop
Mounting
screw
Adjusting
screw
Hinge
22K
10I
61S
www.sauder.com/service