Sauder 426135 Instrucciones De Montaje página 19

Step 13
Slide the MOLDING (J) onto the END (A). Line up the
å
grooves in the MOLDING over the heads of the SCREWS
in the END.
NOTE: The MOLDING should be even on both edges of
å
the END.
NOTE: If the MOLDING comes up off of the SCREWS,
å
remove it and slide it on again.
Repeat this step for the remaining END.
å
Apply pressure with your hands
as you guide the MOLDING over
the SCREWS and onto the END.
www.sauder.com/service
J
A
426135
Now might be a
good time to refresh
your drink.
Page 19