Installation Instructions - SCHÜTTE Carneo Instrucciones De Montaje

Installation instructions

GB
Dear customer,
You have purchased a high-quality and long-
lasting product from our line of goods. Please
read these instructions carefully before assem-
bling and observe the notes.
Therefore, keep the instructions in a safe place
and pass them on to possible subsequent
owners.
Safety notes
• Only allow experts carry out the installation
work.
• CAUTION DAMAGE BY WATER!
Prior to installation please turn the general
water supply off.
• Ensure that all gaskets have the correct fit.
• These taps are not suitable for use on low
pressure and small electrical storage heaters.
• We recommend the installation of a filter
into the appliance or at least the use of angle
valves with filter, in order to avoid the inflow
of foreign matter, which could damage the
upper parts of the valves.
• This tap is only intended for use in private
households! Only suitable for use in rooms
with a temperature over 0 °C, when there is
danger of frost, sut off the water supply and
empty the tap.
• Incorrectly installed fittings can cause water
damages!
• Despite careful production, sharp edges can
occur. Please exercise caution!
Disposal
Your washbasin tap is delivered in a solid pack-
aging, in order to protect it against transport
damages. The packaging consists of recyclable
materials. Dispose it in an environmentally
suitable manner.
Do not throw the product into the normal
domestic waste at the end of its service life,
but ask your municipal administration about
the possibility of an environmentally friendly
disposal.
Technical data
• Recommended water pressure: 1.5 to 6 bar; If
pressure increases to above 6 bar a pressure
reducer should be installed
Installation Instructions
• After installing the tap please unscrew the
mixer nozzle, flush the pipeline and the tap
thoroughly for a longer time, in order to flush
out contaminations and residues.
• Check all connections carefully after first-time
use to make sure that they are tight.
• We do not assume any warranty for incor-
rect installation - in particular for subsequent
damages!
Instructions for care
Sanitary taps require special care. Therefore,
please observe the following instructions:
• Chrome-plated surfaces are sensitive to lime-
dissolving agents, acidic cleaning agents and
all kinds of abrasives.
• Never clean coloured surfaces with abrasive,
corrosive, or alcoholic agents.
• Only clean your taps with clear water and a
soft cloth or a shammy.
Do not forget to unscrew the mixing nozzle
in regular intervals and to remove possibly
calcareous residues or foreign matter. It is
advisable to replace the mixing nozzle with a
new one in the case of extreme contamination.
Maintenance
• Please note that a valve top is a wearing part
and that in the case of very hard or soiled
water the valve must be replaced every 1 to 2
years, as required.
You will find illustrated instructions on how
to replace the valve bonnet on our website
under the following link: web.fjschuette.de/
Austausch_Kartusche-Ventiloberteil.pdf
• Please check all joints and connections for
leaks or visible damages at regular intervals.
12