Battery Charging - Bluewheel IX500 Manual De Instrucciones

BATTERY CHARACTERISTICS
Properties
Type
Loading time
Tension
Max. charging voltage
Max. charging current
CHARGING THE E-SCOOTER
CHARGING THE MOBILE BATTERY
Charging
port
BA TTERY CHARGING
Characteristic value
Li-ion battery
3-4 h
36V
42V
2 A
• Open the cover of the charging port on the handlebar
and make sure it is clean and dry.
• Connect the charger to the battery and the power cord
to the power connection (100V-240V; 50 / 60Hz). Make
sure the charging indicator is lit.
• The charging process is successfully underway when
the indicator lights up alternately. If this is not the
case, check the plug connections.
• When the indicator changes color, it indicates that the
battery is 99% charged. Then stop charging. Overchar-
ging will affect the life of the battery.
• Remove the battery from the handlebar.
• Open the silicone charging connector on the bottom
of the battery
• Charge the battery with the charger and pay attention
to the indicator.
Battery
interface
Properties
Working temperature
Charging temperature
Storage temperature
Storage time
Nominal capacity
Make sure that you close the charging
connections with the dust protection cap
again after the charging process to prevent
a possible short circuit through conductive
parts (metal, liquid).
Do not drive if the battery charge is below
10%. Always fully charge the battery.
38
Characteristic value
0°C - 35°C
0°C - 35°C
-10°C - 40°C
3 months (fully charged)
6,4 Ah