Bestway 13633 Manual Del Usuario página 6

5
6
7
8
FILLING POOL WITH WATER
ATTENTION: Do not leave pool unattended while filling with water
1. Fill pool to drain valve.
STOP
2. Turn water off. Check that the water is not collecting on any side to
ensure the pool is level. If pool is not level, drain water and re-level
ground by digging out. Never attempt to move the pool with water in
it, serious personal injury or damage to the pool may result.
NOTE: Your pool may contain a great deal of pressure. If your pool
has any bulge or uneven side then the pool is not level, the sides
may burst and the water may discharge suddenly causing serious
personal injury and/or damage to property.
3. If level, fill pool to lowest pump valve.
STOP
4. Turn water off. Check valves for
secure fit.
5. Fill pool until water capacity is 90% ,
DO NOT OVERFILL as this could
cause the pool to collapse. In times of
heavy rainfall you may need to empty
some of the water to ensure the level is correct.
6. Check pool for any leaks at valves or seams, check ground cloth for
any evident water loss. Do not add chemicals until this has been
done.
7. In the event of a leak, patch your pool using the underwater
adhesive repair patch provided. Refer to the FAQ's for further
information.
Proper Water Level
NOTE: Drawings for illustration purpose only. May not reflect actual
product. Not to scale.
ATTENTION: Do not use pump when pool is in use.
During the season of use of the swimming pool, the filtration system
must be necessarily put into service every day, enough for a long time
to assure at least a complete renewal of the volume of water.
POOL MAINTENANCE
Warning: If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of children. Pool
water treatment is essential for the safety of the users. Using
chemicals inappropriately will cause property damage and personal
injury.
NOTE: The pump is used to circulate the water and to filter small
particles. In order to keep your pool water clean and hygienic, you
must also add chemicals.
1. It is recommended not to fill the pool with catchment water, drilling
water, or drainage well water: these waters generally contain
polluted organic substances including nitrates and phosphates.
Filling pools with water from the public network is advised.
2. Always keep your pool clean and apply the correct pool chemicals.
Unsanitary water is a serious health hazard. It is recommended to
use disinfectant, flocculant, acid or alkali chemicals to treat your
pool.
3. Clean the PVC liner regularly with non-abrasive brushes or a pool
vacuum cleaner.
4. Throughout the season, the water filtration system must run long
enough each day to clean the entire volume of water in the pool.
5. Check the filter cartridge (or sand in a sand filter) regularly and
replace dirty cartridges (or sand).
6. Regularly check the screws, bolts and all the metal parts for rust.
Replace if necessary.
7. If it rains, check that the water level is not higher than the specified
level. If water exceeds the specified levels, drain the pool to the
specified level.
8. Do not use the pump when the pool is in use.
9. Cover the pool when not in use.
10. For pool water treatment, the pH value is very important.
ATTENTION: Do not leave the drained pool outside.
The following parameters ensure good quality water
6
0°