Drinkwell Platinum Manual De Instrucciones página 3

6) Place fountain in desired location. If placing on carpet, tile or wood
flooring use a protective surface such as a towel or place mat to protect
your floor from splashing or dripping from your pet.
7) Fill the fountain unit with water. This includes the bowl and the filter
housing. This will prime the pump. Replace the lid and snap into place.
8) Remove the reservoir by lifting up and away from the fountain. Turn the
reservoir upside-down and unscrew the reservoir cap. Fill the reservoir
with water and screw on the cap. Holding the reservoir upside-down
and backwards to the fountain (Fig. 1d), quickly turn the reservoir
right side up and slide into place (Fig. 1e). Water level will equalize to
approximately 1/2 inch below the rim of the bowl.
9) Before you plug in the fountain make sure the cord and your hands are
dry. Plug the fountain in.
10) Set your desired flow rate with the flow control knob, located to the right
of the splash ramp. In the 10 o'clock position for a smaller stream or in
the 2 o'clock position for a strong stream. (Fig. 1f)
11) Add water as needed. Do not let the water level fall lower than the flow
control knob or you may burn out the motor. Do not pick up a full fountain
by the filter housing. Only use the handles located on the bottom of the
bowl on either side of the fountain. (For replacement parts please call
866-322-2530)
www.petfountain.com
Fig. 1d
Min.
Fig. 1f
Max
Shown at MAX
flow position.
Fig. 1e
p. 3