Guidance And Manufacturer's Declaration - Electromagnetic Immunity - MedLinket ESM201 Manual Del Usuario

Digital Blood Pressure Monitor should not be used adjacent to or
stacked with other equipment and that if adjacent or stacked use is
necessary, Digital Blood Pressure Monitor should be observed to
Warning verify normal operation in the configuration in which it will be used.
Guidance and manufacturer´s declaration – electromagnetic
emission – for all EQUIPMENT AND SYSTEMS
Guidance and manufacturer´s declaration – electromagnetic emission
1
The model ESM201 is intended for use in the electromagnetic environment
2 specified below. The customer or the user of the model ESM201 should
assure that it is used in such an environment.
Emissions test
3
RF emissions
4
CISPR 11
RF emissions
5
CISPR 11
NOTE: Emission tests for Harmonic distortion, Voltage fluctuations and flicker are
not applicable due to the internally powered ME equipment.
Guidance and manufacturer's declaration – electromagnetic immunity
– for all EQUIPMENT and SYSTEMS
Guidance and manufacturer´s declaration – electromagnetic immunity
The model ESM201 is intended for use in the electromagnetic environment specified
below. The customer or the user of the model ESM201 should assure that it is used in
such an environment.
Immunity test
Electrostatic
± 8 kV contact
discharge
± 2 kV, ±4kV,
(ESD)
±8 kV, ±15 kV
IEC 61000-4-2
air
Compliance
Group 1
Class B
IEC 60601
Compliance level
test level
± 8 kV contact
± 2 kV, ±4kV, ±8
kV, ±15 kV air
Electromagnetic environment – guidance
The model ESM201 uses RF energy only for
its internal function. Therefore, its RF emis-
sions are very low and are not likely to
cause any interference in nearby electronic
equipment.
The model ESM201 is suitable for use in all
establishments, including domestic establish-
ments and those directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic purpos-
es.
Electromagnetic envi-
ronment - guidance
Floors should be wood, concrete
or
ceramic tile. If floors are covered
with synthetic material, the rela-
tive humidity should be at least
30 %.
English 25