VONROC LL505DC Traducción Del Manual Original página 6

EN
LL505DC red laser:
Warning - Laser beam
Never look into the light beam
according to EN60825-1: 2014;
λ: 620-690 nm; P<_ 1mW
LL506DC green laser:
Warning - Laser beam
Never look into the light beam
according to EN60825-1: 2014;
λ: 510-530 nm; P<_ 1mW
2. MACHINE INFORMATION
Intended use
The 360° cross line laser is intended for determi-
ning and checking horizontal and vertical lines
onto the wall and is therefore designed for aligning
objects such as kitchens, walls, ceilings, tiles or
pictures. The line laser is suitable for indoor use.
TECHNICAL SPECIFICATIONS
Model No.
Direction of beams
Colour of laser line
Laser Wavelength
Laser class
Working range*
Accuracy
Self-levelling range
Levelling time
Protection
Tripod connection device
Tripod connection bracket
Recommended tripod
Operating time, max.
Operating temperature
Storage temperature
6
Laser Class 2
Laser Class 2
LL505DC LL506DC
Vertical / 360° horizontal
Red Green
620~690 nm 510~530 nm
II (<1mW) according
to EN60825-1:2014
20m 40m
± 0.5 mm/m
± 6°
4 s
IP 20
1/4"
1/4" and 5/8"
LL801AA
12.5 hours 4 hours
-10~40 °C
-20~70 °C
Rechargeable Battery pack
Battery charging time
Weight (without magnetic
bracket)
Dimensions (without mag-
netic bracket)
* The working range may be reduced by
unfavourable environmental conditions (e.g.
direct sunlight).
DESCRIPTION
The numbers in the text refer to the diagrams on
page 2-4.
1. On / off button
2. Lock switch
3. Laser beam outlet
4. LED indicator
5. Operating mode LED
6. Magnetic bracket
7. Hanging hole
8. Adjusting knob (for height)
9. Mounting wheel
10. ¼ inch tripod connection
11. 5/8" tripod connection
12. 1/4" male threat
13. Magnets
14. USB type-C plug*
15. USB cable*
16. USB type-A plug*
17. USB type-C connector*
* USB Type-C® and USB-C® are trademarks of USB
Implementers Forum.
3. ASSEMBLY
Using the magnetic bracket (Fig. B)
This bracket (6) allows the unit to be mounted to
any upright surface made of steel or iron by using
the magnets (13) at the back. The bracket also has
a hanging hole (7) allowing the unit to be hung
from a nail or screw on any suitable surface.
To fit the 360° cross line laser to the mounting,
proceed as follows:
1. Screw the bracket male thread (12) into the
tripod connection (10) at the device with the
3.7V, 2600mAh (Lithium
battery)
3 hours
380 g
105x60x115 mm
WWW.VONROC.COM