Publicidad
Idiomas disponibles
Idiomas disponibles
8. Recommendations for a proper access to the model
Access
8.1
Remove drain connection R1 and ensure that it does not hamper with the handling of the fan shroud L1.
8.2
Unfasten screws "A" and "B" that secure the fan shroud L1 to the casing and carefully bring the fan shroud to the position
shown in the figure.
8.3
Unfasten screws "C" and remove side panels L2.
8.4
To reach the electric heater R0 positioned under the coil, remove drip tray L5 secured with screws "E".
8.5
In order open the heater terminal box SD (ED models), remove the self-threaded screws "D" that fasten the right-hand
side front cover L3.
8.6
For quick access to header side of coil, remove self-threaded screws "D" that fasten the left-hand side front cover L3.
Reassembling
8.7
Reassemble drip tray L5 with screws "E".
8.8
Place front covers L3 back in place and fasten them with screws "D".
8.9
Reassemble side panels L2 with screws "C"
8.10 When closing the fan shroud L1, make sure that the side panels L2 are inside, subsequently fasten it with screws "A" and
"B".
8.11 Reassemble condensate drain connection R1.
L1
=
Fan shroud
L2
=
Side panel
L3
=
Front panel
L4
=
Supports
L5
=
Inner drip tray
R0
=
Heater
R1
=
Drain connection
SD
=
Junction boxes (fans and heaters)
=
Ground pole
Figure 4
25
www.modine.com
Publicidad
