Modine CGL Serie Manual Tecnico página 39

13. Residual risks
13 .1 The equipment presents a number of risks that have not been fully eliminated from the design point of view or through
the installation of adequate protections . Based on such risks, it is reported which PPE should be used by the operators
or which behaviours and procedures should be adopted .
Sufficient space must be provided during the installation of the unit to limit these risks. To preserve these conditions, the
aisles and areas surrounding the unit must always:
• be kept free of obstacles (such as ladders, tools, containers, boxes...);
• be clean and dry;
• be well lit if necessary .
List of residual risks that remain on the unit:
BURN
ELECTROCUTION
SHARP FINS
CUTTING AND CRUSHING BY BODIES IN MOTION
The operator (in particular situations or during maintenance)
intentionally or unintentionally touches a hot or frozen surface: if
necessary use insulating gloves and/or wait for cooling/heating of
the surfaces .
Contact with live electrical parts during maintenance operations
carried out with the presence of voltage: operations reserved for
qualified and authorised operators, equipped optionally with PPE
and insulating tools - in general, turn off the power supply to the
machine by switching the main switch open "O" and lock it in this
position .
The operator at the stages of use and cleaning must be careful of
the fins as they are sharp.
The operator (in particular situations or during maintenance) must
pay attention to the fans . In general disconnect the fan by placing
the safety switch located near the fan shroud in the open position
"O" .
39
www.modine.com