PLEASE READ THE MANUAL ENTIRELY BEFORE START USING THE SAFE
Bolt-down instructions
To help provide maximum security, bolt down is strongly recommended.
1. Select a suitable and convenient location for your safe. Set the safe in place
and use the holes provided in the bottom and /or back of the safe to mark the
location of the holes to be drilled in the floor or wall. If bolting to a wall, please ensure
that the safe is resting on a supporting surface, i.e. floor, table, shelf, bracket.
2. Move the safe away and drill holes of the appropriate diameter and depth
for the type of hardware being used and the mounting surface.
3. Place the safe back over the holes and install the fasteners as required.
Using the Override Key to Open the Safe
Using your finger nail, remove the override key lock cap located at the front of the door. Fig. 1.
Insert the override key with the notch of the override key at the top edge, See Fig. 2.
Turn the key clockwise 90 degrees and open the door, the display will show "nAnUAL".
With the door open, turn the key counterclockwise 90 degrees and remove it. The bolts will be
extracted. Press the "LOCK" button, the bolts will be retracted automatically.
Fig.1
Fig. 2
NOTE: DO NOT STORE THE OVERRIDE KEY IN YOUR SAFE!
Please secure your override keys in a safe place. If the override
keys are lost or damaged, contact your local ExecutiveSafe office.
Battery Installation
Four alkaline AA batteries (included) are required.
NOTE: Non-alkaline or rechargeable batteries ARE NOT RECOMMENDED.
To install the batteries, remove the battery cover located on
the inside back side of the door, as indicated. See Fig. 3. Insert the four
batteries as indicated See Fig. 4. Insert back the battery cover.
Fig. 3
Fig. 4
Batteries should be replaced:
If the safe is closed and the "LOCK" key is pressed and the display shows "bA - LO".
The display shows "bA - LO" during entering of a code or during the opening or closing state of
the safe.