Output Setting; Network Display Setting - Esoteric N-01 Manual Del Usuario

Digital filter setting during DSD playback
DSDF> ***
o This setting can be made for each input.
OFF
The digital filter that cuts high-frequency harmonic content from
the DSD signal is not used.
o If the volume is adjusted (to a value other than 100) using the
app when the DSD filter is set to OFF, the unit itself will turn it
ON and adjust the audio output. This setting, however, will not
be changed.
If the volume is reset to maximum (100) using the app, the unit
will turn the DSD filter off again.
ON
The digital filter that cuts high-frequency harmonic content from
the DSD signal is used.
o In NETWORK mode, this is automatically turned on when the app
is used to adjust the volume (0–99).
Clock sync mode setting
CLK> ***
o This setting can be made for each input.
o During XLR, RCA or OPT input, input a clock that is synchronized
with the input source. If the source device does not support clock
input, set this to OFF.
o During NETWORK and USB input, the clock frequencies that can
be input depend on whether the playback file is 44.1 or 48 kHz.
10MHz clock can be input for any type of playback file.
OFF
Clock is not synchronized.
IN
This unit's master clock is synchronized to the clock signal (44.1 kHz,
48 kHz, 88.2 kHz, 96 kHz, 176.4 kHz, 192 kHz or 10 MHz) input
through the CLOCK SYNC IN connector and used for operation.
MCK
The 22.5792MHz/24.576MHz signal input through the CLOCK
SYNC IN connector is used as the master clock.

Output setting

OUT> ***
XLR2
Analog audio signals are output through the XLR connectors with
pin 2 HOT.
XLR3
Analog audio signals are output through the XLR connectors with
pin 3 HOT.
RCA
Analog audio signals are output through the RCA connectors.
ESLA
Analog audio signals are output as ES-LINK Analog through the
XLR connectors.
ATTENTION
This unit will not output audio from the unselected analog audio
output connectors.

Network display setting

DISP> ***
Fs
This shows the sampling frequency being input.
If there is no input signal or the unit is not locked to the input sig-
nal, the input sampling frequency is not shown.
TIME
This shows the elapsed time of the song being played.
17