Ultenic T10 Manual Del Usuario página 5

LDS cover
(with bumper sensor)
Air outlet
Cliff detect sensors
Side brush
Left wheel
Rolling brush
LED indicator
• Flashing blue light: Powering on/configuring network/upgrading firmware
• Solid blue light: Powered on/normal working state
• Flashing yellow light: Low battery/recharging
• Flashing green light: Charging
• Solid green light: Fully charged
• Flashing red light: Error state
• Light off: Power off/sleeping
Charging contacts
Dustbin release button
Dust collection port
2-in-1 dustbin & water tank
Power button
• Long press to turn on / off
• Short press to start / pause cleaning
Home button
• Short press to start/pause recharging
Omnidirectional wheel
Right wheel
Brush cover
�. Dustbin & Water Tank
Dustbin latch
Water fill cap
Dustbin release
button
Dust outlet
�. Auto Empty Base
Cover
LED display panel
Infrared lens
Charging/Dust
collecing contacts
Dust inlet
Seal ring for cover
Fan filter
Status Indicator
• Solid green light: Collecting dust
• Flashing red light: Fan overheating/fan
error/cover not closed
Power Indicator
• Flashing green light: Charging
• Solid green light: Fully charged/standby
Dust Bag Indicator
• Solid green light: Dust bag is full/dust duct
is blocked
• Flashing red light: Dust bag is not installed
/dust bag is not installed correctly
Pre-filter
Foam filter
HEPA filter
Washable mopping
cloth
Paste area
Mopping cloth holder
Mop attachment latch
Dust collection
duct cover
Air outlet
Power interface
Dust bag handle
Dust bag