Descargar Imprimir esta página

Klarstein RHONE 25 DUO Manual De Instrucciones página 67

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

PROBLEM
The appliance seems to
make too much noise.
The door will not close
properly.
E0, E1, E2, E3, E4, E5, E6,
E7, E8 or E9 appears on
the display.
Alarm sounds and tem-
perature
display NOT flashing (do
or alarm).
The alarm sounds AND
the temperature display
flashes (temperature-
alarm)alarm).
POSSIBLE CAUSE
The rattling noise may come from the flow of the refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds caused by the flow of refrig-
erant in your appliance.
If temperature fluctuations occur, the contraction and expansion of the inner
walls may cause popping and crackling noises.
The appliance is not properly level.
The appliance is not properly level.
The door was reversed and not prop-
erly re-installed.
The gasket is dirty.
The shelves are out of position.
Error codes.
Door has been left open longer than
60 seconds.
Has the appliance door been open for
longer than 60 seconds? If not, then
the temperature has risen higher or
fallen lower than the temperature
that has been set. This could be due
to:
- The appliance door being opened
too often.
- The ventilation opening being cov-
ered or too dusty dusty.
- A lengthy interruption to the power
supply.
- A large amou nt of bottle s has been
added to the unit
REMEDY
Level the appliance with the adjustable
feet.
Level the appliance with the adjustable
feet.
• Check the door hinge and reassemble
correctly
• C lean the door gasket.
• Check the shelves and refit correctly.
Try resetting the controls by discon-
necting power to the unit for 5 minutes,
then reconnect. If error code returns,
problem cannot be resolved by user.
Call for service.
Close door, or touch any key to disable
alarm. Alarm will reset when door is
closed.
If yes, close the door.
- Do not open the door more often than
necessary
- Clear the obstructions and clean the
dust.
- Leave the appliance to work for a
while until the set temperature has
been reached.
EN
67

Publicidad

loading

Este manual también es adecuado para:

10041239