Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
image 8 on page 6.
Press
,then the
disappear and unit go into free normal
mode (note: units always go into free use
normal mode from the stand-by mode).
Free program
For the first time use, the screen will be
shown as image 9 on page 6.
• Time setting:
• Press
button and the hours will
start to blink, then you can use
or
to select the required hour (0
~ 23).
• Press
will start to blink.
• Use
or
(0 to 59).
• Pressing
date start to blink, then use
to select the date
• (1-Monday, 2-Tuesday, 3-Wednesday,
4-Thursday,
7-Sunday)
• Finally press
finish the setting.
• If there is no pressing, the blinking
will stop after 5 seconds and the
setting will be finished automatically.
• Temperature setting:
• Press
temperature directly and at this point
the temperature starts to blink.
• Press
temperature.
• Temperature adjustable range is from
10 ºC ~ 35 ºC.
• If no buttons are pressed, the blinking
will stop after 5 seconds and the
setting will be finished automatically.
38
symbol will
again, and the minutes
to select the minute
again, will make the
5-Friday,
6-Saturday,
to confirm and
to
set
the
to
set
the
• Timer setting (timer mode)
• Hold
symbol is shown.
• At the same time the clock will turn
to 00:00 and start to blink.
• This means the timer setting starts
as image 10 on page 6.
• Press
length, every button press will
change half an hour (30 minutes).
• The maximum timer length is 24
hours.
• When the timer is over, the unit will
enter into standby mode
• You
temperature the same as previously.
• To quit from timer mode: hold the
• The unit will automatically return
back to free normal mode afterward.
or
Note: Once the machine exits free program
(enter the day, week program, or standby),
and then return to the free program, the
unit always enters into the free normal
mode first. The original timing model will
be automatically cancelled.
• Running mode selecting:
• Press the
program selecting (Program No.
start to blink).
• Press
mode:
target
•
• Then press
target
• The unit will run following the new
selection program.
Note: During this period, if no buttons are
pressed, the selection is automatically
completed 5 seconds later.
for 3 seconds until the
or
to set the timer
can
also
set
button for 3 seconds until the
symbol has disappeared.
button to get into
or
to select running
,
~
,
to confirm it .
.
time
and
Publicidad
