Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTION
• Connect to power supply, the heater
will enter into standby mode, screen
show (Please note the Wi-Fi symbol
is flashing at this moment).
• There are two ways to connect WiFi:
Smart mode and AP mode. Usually
we recommend to connect WiFi
by Smart mode, but if Smart mode
doesn't connect sucessfully, you can
try AP mode again.
• Under standby mode, press and
hold
enter into Smart mode connection,
screen show. Then press and hold
button for 3 second again to
enter into AP mode connection,
screen show. Repeat this operation
to change to Smart mode again.
• Once you have confirmed that the Wi-
Fi symbol is flashing open the app
and press "Add device" (centre of the
screen) or "+"(top right). Many devices
automatically detect the appliances
if they are near (in this case you only
need to select it to add it). If this is not
the case, follow these steps: See image
26 on page 9.
• Now find the right category (Small
appliance, 5th category, it is shown as
"Appliance p...") and select your product
(Heater (Wi-Fi"). See image 27 on page
9.
• Once you have selected the product you
must enter the password of your Wi-Fi
network (check beforehand that your
network is 2.4GHz and that the signal is
good). See image 28 on page 9.
Note: The closer you are to the router the
better the connection will be when you
link the device.
• Check that the Wi-Fi indicator is
flashing rapidly (Smart mode) or
slowly (AP mode). If none of these two
options happen, follow the instructions
provided by the APP by pressing "Reset
your device step by step". If it still does
button for 3 second to
not work, try unplugging the appliance
for a few minutes and connect it again
later. See image 29 on page 9.
• When
the
flashing
correctly the APP is ready to find the
device; this process might take a few
minutes.
• When the APP finds the device it will
show on the screen, and you must press
to select and add it. See image 30 on
page 10.
• Once added you will have access to
control the device from the homepage.
You can set some shortcuts on the main
page of the APP where you can find all
the linked devices. See image 31 and 32
on page 10.
Controls from the APP
Once you have connected your product,
you will be able to use the APP to control
the following functions (See images 32 to
37 on page 10 and 11):
• Switch on and off
• Temperature
• Mode
• Weekly programming
• "Open window" function
• Timer
Note: The appliance can be controlled with
the app or with the control panel on the
appliance itself, but not with both.
When you enter the main control screen of
the appliance you will find these functions:
• Temperature control (dial or buttons
"+/-"):
each
temperature previously set for that
mode and every time you select that
mode the temperature will be set
automatically (you can change at
any time the temperature settings
for the "ECO" and "Comfort" modes;
The settings of the "Anti-freeze" mode
cannot be changed, the temperature
will always be 7ºC)
• The
temperature
mode must always be lower than
the temperature on the "Comfort"
is
happening
mode
will
save
on
the
EN
the
"ECO"
41
Publicidad
