Publicidad
Idiomas disponibles
Idiomas disponibles
MediPendant_Manual_7-16-10.pdf
MediPendant
INSTALLING/REPLACING THE BATTERY
The pendant operates on one (1) lithium photo 123 battery. While your
pendant comes with one battery pre-installed, a second one is provided for
your convenience and should be stored in an easily accessible place. Lithium
photo 123 batteries are available at most drug and convenience stores – or
can be purchased through our toll-free customer service number. The
pendant allows up to 6 hours of talk time. Under normal use, the battery
should last 6 to 12 months (depending on talk time).
PENDANT BATTERY INSTALLATION See Figure 18A
STEP 1: Remove cover on back
of pendant by removing screws
using supplied screwdriver.
STEP 2: Insert battery following
C
+ / – indication inside pendant.
M
STEP 3: Slide screw through
Y
O-ring, placing O-ring at top of
CM
screw before fastening.
MY
STEP 4: Replace cover on back
of pendant replacing screws.
CY
CMY
NOTE:
Screws for battery door are 2 different lengths. Please make sure
longer screws are at top of pendant and O-rings are properly installed.
K
NOTE:
Be sure to re-install battery strap when installing new batteries.
BASE STATION BATTERY INSTALLATION See Figure 18B
Your base station battery is pre-installed and should not have to be replaced.
If the battery does need to be replaced, follow the steps below.
STEP 1: Remove cover on back
of base station.
STEP 2: Unplug used battery
from terminal clips.
STEP 3: Install new battery to
terminal clips. Make certain
terminals line up properly to
avoid accidental damage.
STEP 4: Replace cover on back
of base station.
18
21
7/16/10
™
Terminal
2:07 PM
O-ring
Figure 18A
Clip
Base
Station
Battery
Base Station
Cover
Figure 18B
Publicidad
