Novoferm tormatic T100 DES Manual De Instrucciones Y De Montaje página 29

Menu 5 Various settings
Menu Entry Selection
item
50 Key switch function (J7)
0 Pulse input OPEN/CLOSE (default setting)
1 Inhibit control panel
2 Inhibit external control elements
3 Inhibit control panel and external control
elements
4 Activate control elements for 10 seconds
5 Switch-over to dead man mode for closing
6 Switch-over to 1/2 opening (winter mode)
7 Pulse input OPEN-STOP-CLOSE
8 Pulse input 1/2 OPEN-STOP-CLOSE
9 Pulse input for smoke and heat extraction
system (setting in menu item 55)
10 Activate control elements for 300 seconds
11 Input for electrical interlocking EDL100
51 Function of external control devices
0 Three-button-control (default setting)
1 Open-Stop-Close function (J1.3 1/2, J1.4 full
opening)
52 001-256 Entry of control address
53 Door control module and inflatable door sealing
0 Off (default setting)
1, 2, 3, 4 For control profiles see control door module
5 RadioBand module, wireless closing edge
(optional)
6 Reserved
54 Extended control
0 Off (default setting)
1, 2, 3 For control profiles see extended control
55 Door setting for smoke and heat extraction
system position
59 18 Do not change control variant!
- - Exit menu
Menu 6 Radio
Menu Entry Selection
item
60 Programming the start button on the hand-held
transmitter
61 Programming the 1/2 opening button on the hand-
held transmitter
62 Programming the light button on the hand-held
transmitter
63 Deleting radio codes
Press for 5 s
- - Exit menu
Menu 7 DU settings
Menu Entry Selection
item
71 Opening speed
20 - 65 Speed in revolutions / min.
30 Factory settings
72 Closing speed
20 - 30 Speed in revolutions / min.
20 Factory settings
73 Increased closing speed
20 - 30 Speed in revolutions / min.
20 Factory settings
74 Door setting change-over point [73] to [72]
75 Acceleration time open
10 - 30 x 0.1 s
20 Factory settings
76 Acceleration time close
10 - 30 x 0.1 s
20 Factory settings
77 Braking time open
10 - 30 x 0.1 s
20 Factory settings
78 Braking time close
10 - 30 x 0.1 s
20 Factory settings
- - Exit menu
Menu 9 Service menu
menu Entry Selection
item
90 Selection of the door maintenance cycle
0 No service interval (default setting)
1 1000 cycles
2 4000 cycles
3 8000 cycles
4 12000 cycles
5 16000 cycles
6 20000 cycles
7 25000 cycles
8 30000 cycles
9 35000 cycles
10 40000 cycles
11 45000 cycles
12 50000 cycles
91 Cycle counter output door cycles
96 Operating hours counter output – hours
97 Error memory output hours – error code
98 Software version output – serial number – creation
date
99 Reset to default setting
Press for 5 s
- - Exit menu
T100 DES EN - 27