Profi Care PC-HSM Manual De Instrucciones página 20

1. Turn the appliance off. 0 can be seen on the switch (6).
2. Connect the power supply plug with one of the following jacks:
• The socket (5) directly at the bottom end of the appliance.
• Alternatively place the appliance in the charging station. The socket is at the
rear.
3. Plug the power supply unit into wall outlet.
4. Charge the appliance before first use for 10 hours.
• The indicator light remains red during the charging process.
• The charge indicator does not indicate the state of charge of the rechargeable
battery.
• If the rechargeable battery is empty, the appliance can be operated via mains
power. In order to do so, connect the power supply unit directly to the appliance.
5. After initial use, do not charge the battery for longer than 8 hours at one time.
• After 8 hours always disconnect from mains power supply.
You will extend the life of the rechargeable battery if you observe the following:
• Wait until the rechargeable battery is almost empty before charging.
• Do not leave the appliance connected to the charger for more than 14 hours.
• Only charge the appliance at an ambient temperature between 0 °C and + 40 °C.
Switching On and Off
Slide the switch (6) to turn the appliance on or off.
Table: Cutting Step Versus Cutting Length
Cutting Step
1
3
5
20
PC-HSMR3052NE_IM_new2
Charging the Battery
Using the Appliance
Cutting Length
approx. 3 mm
approx. 6 mm
approx. 10 mm
Cutting Step Cutting Length
7 approx. 13 mm
9 approx. 16 mm
16.11.22