Bimar TEKNOARREDO Folleto De Instrucciones página 8

Fax +32 030 9904733
Insert the plug in the socket, appears and the room temperature is displayed.
Ventilation:
To turn the fan on, press the " " key on the remote control or the control panel. The fan will start at
the medium speed.
To select the desired speed, repeatedly press the "SPEED" key: on the control panel shows
selected speed (minimum "I", medium"II" or maximum "III").
Horizontal oscillation (right-left): this is controlled by the "OSC" key on the remote control or the
pushbutton panel.To eliminate this motion, press the "OSC" key again.
Timer: this function allows setting the operating time and the fan will automatically stop at the end.
• To set the operating time, repeatedly press the "
every time the key is pressed, the time set is changed and the indicator light on the control panel lights
corresponding to the time selected (1 hour, 2 hours, ecc....): the maximum time is 12 hours. To turn off
the timer, set the maximum time and then press the "
• Mode: the fan can work at a constant speed (
speeds: "Sleep" e "Natural". To active the "Sleep"mode, press the taste until on the display show
symbol on the display: if you set the minimum speed the fan runs at minimum speed constant. If
you set the average speed of the fan runs at two different speeds intermittent medium and low, with
rounds of 30 minutes each. If you set the maximum speed the fan runs at three different speeds
intermittent maximum, medium and minimum, with rounds of 30 minutes each. To activate the
"Natural", press the button until the icon appears
maximum, medium and low speed with cycles of about 5 seconds each.
To turn the fan off, press the " " key on the remote control or control panel, then remove the plug from
the socket.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your hand
in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make sure that
all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• Periodically check that the air-intake grill is not obstructed by fuzz or threads.
• It is essential that the motor's air holes be kept from dust and lint.
• Periodically check the electric cord for damage; its replacement requires a special tool: contact an
authorized service center, also for any repairs.
• If the fan will not be used for long periods, it must be protected from dust and humidity; we
recommend storing it in its original packaging.
• Should you decide not to use the appliance any more, we recommend making it inoperative by cutting
the power cord (after making sure you have disconnected the plug from the socket) and make
dangerous parts harmless if children are allowed to play with them.
• Do not dispose of non-biodegradable products in the environment but dispose of them in accordance
with current law. At the end of its working life, the product must not be disposed of as urban waste. It
must be taken to a special local authority differentiated waste collection centre or to a dealer providing
this service. Disposing of a household appliance separately avoids possible negative consequences for
the environment and health deriving from inappropriate disposal and enables the constituent materials
to be recovered to obtain significant savings in energy and resources.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
" key on the remote control or the control panel:
" key again.
) min, med, max, or with two different intermittent
on the display alternately the fan runs at
8 20
/
Assembly page 8/20
the