Publicidad
Idiomas disponibles
Idiomas disponibles
Noise and Vibration Measurements:
Sound pressure level: < 70 dB(A)
3.6. Tool safety requirements
The chainsaw is safe if it meets the following requirements:
1. The chain is not damaged
2. The chain tension is correct
3. The bar is not deformed
4. The bar slot is intact or in good
working order.
5. The chainsaw is clean and dry
6. The handle is intact or in good working
order.
7. The safety switch and the trigger work
properly
4. Intended use
The tool is designed for pruning branches only. Use other than that indicated can damage the tool, be
dangerous and cause damage. The tool is designed for adult use only, do not use in rainy weather or to work
on wet plants or bushes. The manufacturer is not responsible for damages caused by the non-observance of
the instructions in this manual.
Check the correct tension and sharpening of the chain before using the tool.
Damages caused by the use of an not sharpened and / or incorrectly tensioned chain are not
covered by the warranty.
5. Description of the features
The tool is suitable for pruning branches and cutting small diameter trees. The ergonomic handle allows
to work safely. It is recommended to comply with the warnings contained in this user manual.
In case of danger or malfunction release the trigger, the chain will stop to prevent damage or injuries.
6. Overview of the tool
1) Chain
2) Bar
3) Chain protection
4) Oil cap
Max vibration during use: < 2.5 m/s
8. The lubrication of the bar, chain and gearbox is
adequate.
9. The depth of the groove between the pinion and the
chain is not more than 0.5mm
10. Bar and chain are assembled correctly as
specified in this manual
11. Any accessories used are conform and
original
12. The oil cap is closed correctly and has all its parts in
good condition.
5) Safety trigger
6) Trigger
7) Handle
2
32
Publicidad
