Descargar Imprimir esta página

Kamikaze KVS5500 Guia Del Usuario página 43

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

If you do not see traces of oil, check that you have refilled the tank, if the tank is full, disassemble the bar,
clean the oil outlet hole of the machine and the oil inlet hole on the bar. Reassemble and repeat the
procedure. If the problem persists, contact our technical service.
Warning!
Never use the chainsaw if the lubrication system is not working properly.
14.6. Pinion and bar inspection
• Disconnect the battery from the chainsaw.
• Use the Allen key supplied to unscrew the two locking nuts ① and remove the cover ②.
• Remove the chain and the bar.
• Measure the depth of the chain groove using a depth gauge.
• If the depth of the groove exceeds 0.5 mm, do not use the
chainsaw and contact the service center to replace the pinion of
the chain.
• Measure the depth of the pinion of the chain slot using a depth
gauge.
• If the depth is less than 1.1mm, if the bar is damaged or the slot
is deformed, replace the bar to avoid damaging the chain and the
chainsaw.
15. Storage
The most important thing to keep in mind before storing your chainsaw is the lithium-ion battery. Make
sure that the batteries are fully charged.
If storing the battery for a long time with low charge will damage the battery and invalidate the
warranty.
1) Make sure the battery is fully charged.
2) Avoid storing the device in extremely hot or cold environments.
3) If the device will not be used for a long time, please remove the battery before storing it.
4) Batteries and chargers should be placed in a safe place to prevent the entry of heat, dust and
42

Publicidad

loading