Pioneer FS-SW40 Manual De Instrucciones página 9

Pairing with the Controller
When setting up the Controller for the first time
1. As with the speakers you purchased at the same time,
firstly connect the power cord of the unit.
2. After referring to the Quick Start Guide for FS-W40,
connect the Controller and turn the power on. The Initial
Setup screen is displayed automatically on the
television, so use the cursors and ENTER buttons on the
remote controller, following the on-screen instructions to
complete the settings.
If you add this unit later
1. Connect this unit's power cord.
2. Set the input selector on the TV to the position the
Controller is connected to.
3. Turn on the power of the Controller and press SETUP on
the remote controller.
4. Use the cursor and ENTER buttons on the remote
controller and select "Wireless Speaker" → "Scan" →
"Next" on the TV screen.
Scan
Speakers currently paired:
Front Left : Yes
Front Right : Yes
Surround Left : No
Surround Right : No
Subwoofer : No
Ensure all speakers are connected to the power supply.
Next
Cancel
5. When the speaker has been detected, select "Save" to
save the pairing information.
The CONNECT LED
This flashes red when unpaired
with the Controller and lights blue
when pairing is complete. Also,
when Wireless Speaker Standby
has been set to on on the
Controller, this lights red when the
Controller is in standby mode.
When submitting the controller or the speakers for
repairs, please submit both the controller and the
speakers.
Select a flat, stable location to place the unit.
CONNECT
En
9