Danfoss VLT MCD 600 Guia De Instalacion página 5

VLT® Soft Starter MCD 600
Installation Guide
1 Instructions
1.1 Safety and Installation Awareness
Before starting installation, read all safety guidelines and precautions in this installation guide. Additional documentation can be
accessed by scanning the QR code on the front cover. PC tools can be downloaded from www.danfoss.com.
1.2 Qualified Personnel
Only qualified personnel are allowed to install, commission, and maintain Danfoss drives. Qualified personnel are trained individuals
who are familiar with and authorized to mount and wire the drive in accordance with pertinent laws and regulations. Also, qualified
personnel must be familiar with the instructions and safety measures described in this installation guide.
1.3 Safety Symbols
The following symbols are used in this guide:
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information considered important, but not hazard-related (for example, messages relating to property damage).
1.4 Safety Precautions
Safety precautions cannot cover every potential cause of equipment damage, but can highlight common causes of damage. It is the
installer's responsibility to:
• Read and understand all instructions in this manual before installing, operating, or maintaining the equipment.
• Follow good electrical practice including applying appropriate personal protective equipment.
• Seek advice before operating this equipment in a manner other than described in this manual.
The VLT® Soft Starter MCD 600 is not user serviceable. The unit should only be serviced by authorized service personnel. Unau-
thorized tampering with the unit voids the product warranty.
DO NOT USE AS SAFETY SWITCH
Stopping the soft starter does not disconnect the equipment from mains voltage.
-
Do not use the soft starter as a safety switch.
Danfoss A/S © 2023.03
D A N G E R
W A R N I N G
C A U T I O N
N O T I C E
N O T I C E
W A R N I N G
Instructions
AN43852230046601-000101 / 175R1190 | 5