Functions Of The Keys - Metrix MX 407 Manual De Instrucciones

The measured resistance value is displayed on the screen.
3.2

Functions of the keys

The functions of the
,
accessed by successive short or long presses. Each press is
confirmed by an audible signal.
3.2.1
key
This key is used to hold the display of the measured value, for all
positions of the switch. The HOLD symbol is displayed on the
screen.
For insulation measurements, the HOLD is activated automatically
after each measurement.
Special case when the device is started up: a long press at start-up
de-activates the automatic switching off of the device.
Each press of
this length...
Any
short
position
3.2.2 key
This key is used to hold the insulation measurement in permanent
mode (measurement campaigns, for example).
The symbol is displayed on the screen.
keys can be
, and
...serves
to hold the display of the
measured value;
to exit from the HOLD mode .
29