Heath Zenith SL-6200 Manual De Instrucciones página 5

Figure 3
598-1144-03
3. Test range. Temporarily position
push button where you want it
mounted. Press each push button
to verify chimes and push buttons
work properly. If either chime does
not sound, see Troubleshooting.
4. Mount push button. Use either
screws or double sided tape to
mount push button.
• Screw Mounting: To mount with
screws, remove back of case by
pushing in tab on bottom with a
small screwdriver (see Figure 1).
Note: Remove material in screw
holes (if needed) before mount-
ing with screws. Attach back of
case to door jamb or wall (see
Figure 3). Snap front of push
button on.
• Tape Mounting: When attaching
push button using double sided
tape, make sure the surface of
the door jamb or wall is clean.
-5-