Heath Zenith SL-6200 Manual De Instrucciones página 8

A. Chime does not sound:
• Make sure push button and chime codes are the same (see
Figure 2).
• Check orientation of push button battery (See diagram
inside push button for correct battery orientation.)
• Check charge of push button and chime batteries (if ap-
plicable), replace if necessary.
B. Chime sounds when not intended (false triggers): Chime
is receiving interference from another wireless device;
change the code setting (see Set the code for each button
and the matching chime).
C. Batteries seem OK, but the chime does not work when
installed:
• Do not mount chime or push button on metal or near metal
studs.This reduces the transmitter range. Use 1/4" to 1/2"
(6 to 13 mm) wood shims to move chime or push button
off metal surface.
• Concrete floors may reduce range. Move chime away from
floor.
• Try locating chime closer to push button.
The range of the wireless chime can vary with location, tem-
perature and battery condition.
Troubleshooting
-8-
598-1144-03