Publicidad
Idiomas disponibles
Idiomas disponibles
WHAT TO DO IF...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Acoustic or visual alarm is on.
The compressor operates con-
tinually.
The compressor does not start
immediately after pressing the
"FastCool", or after changing
the temperature.
Door is misaligned or interferes
with ventilation grill.
Door does not open easily.
The lamp does not work.
There is too much frost and
ice.
Possible cause
The appliance is switched off.
The mains plug is not connec-
ted to the mains socket cor-
rectly.
There is no voltage in the
mains socket.
The appliance is not supported
properly.
The door is left open.
Temperature is set incorrectly.
Many food products were put
in at the same time.
The room temperature is too
high.
Food products placed in the
appliance were too warm.
The door is not closed correct-
ly.
The FastCool function is
switched on.
The compressor starts after a
period of time.
The appliance is not levelled.
You attempted to re-open the
door immediately after closing.
The lamp is in stand-by mode.
The lamp is defective.
The door is not closed correct-
ly.
The gasket is deformed or
dirty.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Close the door.
Refer to "Control panel" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to "Installation" chapter.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door"
section.
Refer to "FastCool function"
section.
This is normal, no error has oc-
curred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of the
door.
Close and open the door.
Contact the nearest Author-
ized Service Centre.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
13
Publicidad
