Hayward Powerline 81RFBOX2C Manual Del Usuario página 3

EN INSTALLATION GUIDE: RADIO FREQUENCY CONTROL BOX
Operating principle:
• Control any LED lights available on the market using radio remote control.
• Manage your pool lighting from just one control box.
• For RGB lights, synchronise all LED lights and select a programme as desired for a customised mood.
Description of device:
This radio frequency control box is designed for indoor/outdoor use. It controls (turns on / switches off / changes programme) the pool LED spotlights remotely. It is
compatible with any LED spotlights on the market with supply voltage of ~12V. A radio remote control allows instructions to be sent remotely to the control box (distances
of 0 to 50m).
Regulations and certification:
It is a class III radio equipment appliance with a very low safety voltage of ~12V. This radio control module has an IP65 protection rating.
This radio control module also complies with international electrical safety regulations, in particular the international regulation IEC 61059-1: 2002 + A
Principle of control box connection:
This Powerline control box must be supplied by the secondary circuit of a double insulated transformer, in compliance with current regulations for pool LEDs.
(Primary: ~230V / Secondary: ~12V). The lights can be controlled either by the switch on the control box or with the remote control.
Remote control
receiver
Pool
electrical
cabinet
230 V 12 V
Main supply Secondary
to cabinet circuit of lighting
transformer
Wall installation, cabling and connection of control boxes
2-CHANNEL BOX
Dim.: 138x116x50mm
Terminal: 2 outputs
On/Off switch
MAX POWER = 120W
Pairing of the radio remote control and the control box:
• The control box and the radio remote control are already paired and programmed
together.
• If the control box does not respond, follow these steps:
1. Press and hold the black button (1), the green LED will flash (2), release the
button. The LED remains on.
2. Press and hold the remote control button (3) for 3 seconds, the green LED
will flash (2), release the button. Pairing is complete.
3. You can repeat the procedure for 2 control boxes. One remote can control
2 boxes.
Operation with Hayward LED lights
• All Hayward LED lights (PAR56, flat, mini) can be connected and twinned on a
single control box.
• Synchronisation: to turn on all LEDs connected to the same control box on
programme 1 (white), switch off and restart the control box between 6 and
15 seconds later.
• Change of programme: switch off and restart the control box between 1 and
3 seconds later.
• Memory: all LEDs will turn on with the programme most recently selected if the
control box is switched off for more than 30 seconds.
Remote control
emitter
12 V
6-CHANNEL BOX
Dim.: 224x143x75mm
Terminal: 6 outputs
115
:
®
LED spotlight
1 2
184
On/Off
switch
MAX POWER = 120W
2
Warnings:
• The control box must be installed indoors or sheltered by a roof.
• Don't connect the control box directly to a ~230V or ~110V power supply.
• Stay within the maximum permitted power for each product.
Only use spare parts supplied by Hayward® brands
8-CHANNEL BOX
Dim.: 242x175x102mm
Terminal: 8 outputs
On/Off switch
MAX POWER = 300W
1
182
3