Install the Camera
1. Installation precautions
•
Do not face the camera to any light source.
•
Do not point the camera at glass windows or reflective objects. Otherwise,
it may result in poor image performance due to reflections from infrared LEDs,
ambient lights or status lights.
•
Do not mount the camera in shaded area, and point the camera towards
a well-lit area. For better image quality, make sure the camera and the
captured subject are at the same lighting conditions.
•
For optimum performance, it is recommended that the camera be installed as
far away as possible from electronic devices such as microwaves, televisions,
radio phones and baby monitors to prevent signal interference.
•
It is recommended to clean the lens with a soft cloth from time to time.
•
Do not expose the power port to water or moisture, or blocked by dirt or
other things.
•
Do not install the camera where rain and snow may hit the lens directly.
•
Camera may work in extremely cold conditions as low as -10°C as it will
produce heat when powered on. You may power the camera indoors for a
few minutes before installing it outdoors. (Only for outdoor cameras)
2. Mount the Camera to the Wall
Drill holes according to the mounting template.
NOTE:
Use the anchors included in the package if needed.
Attach the camera bracket with screws included in the package.
NOTE:
Run the cables through the cable notch on the mounting base. For
WiFi cameras, it is recommended to mount the antenna upward or
horizontally for better WiFi connection.
5
English