Brandt BFC2062NX Manual De Instrucciones página 38

Space required
• Choose a location that is not directly to sunlight.
• Choose a location with enough space so that the refrigerator can open easily.
• Allow for a safety distance on the right-hand side, left-hand side, back and above the
appliance when installing it. This optimises product performance, reduces your power
consumption, and therefore limits your electricity bill
• Make sure that air can freely circulate behind the appliance.
It must be possible to fully open the appliance door as shown on
the diagram. L×P≥990×1025m

Note that this appliance is not designed for built-in installation.
Levelling the appliance
Choose a place to install the refrigerator on a flat surface.
Procedure for adjusting the feet at the front of the
product
Electrical connections
Warning!
so the plug must remain easy to access after installation.
• The electric connections must meet the applicable standards and be capable of withstanding
the maximum power shown on the ID plate.
• The power plug must be easily accessible and out of the reach of children.
• For your safety this appliance must be earthed. If the power plug is not earthed, consult a
qualified electrician to connect your appliance in line with applicable regulations.
• Do not use extensions, adapters or multiple plugs.
• Do not place multiple plugs or portable power supply units behind the appliance.
The manufacturer declines all liability if the above mentioned safety precautions are not
complied with. If in doubt, refer to your reseller.
If the appliance is not level, the doors will not be correctly aligned and the
compartment seal cannot be guaranteed.
To level the appliance laterally, adjust the two adjustable feet on the front
of the product.
Once the appliance is installed, ensure that it is slightly inclined rearwards.
In this way, it will be easier to close the door. If necessary, adjust the
setting of the adjustable feet.
It must be possible to unplug the appliance from the mains power,
W
Lower
Raise