Emos One Touch Pro ESI2010 Manual Del Usuario página 3

GB | One Touch Digital Tap
Timer Pro
Specifications
Max operating
pressure
Working
temperature
Waterproof
Watering frequency
Watering duration
Max flowing
Power supply
Battery life
Fault resolvent
LEDS off
Watering is not
functional
Water flow is weak
Buttons (see fig. 1)
1 – SETTING BUTTON
2 – WATERING FREQUENCY
3 – ON
4 – ¾ INCH INLET
5 – OFF
6 – WATERING DURATION
7 – ¾ INCH OUTLET
BATTERY INSTALLATION
Use only 1.5 V alkaline batteries, do not use
rechargeable batteries.
The timer will stop working and the LED indicator
(OFF) flashes red when battery power is low.
Unscrew the controller by hand form the housing
of water timer, remove the cap of the battery
compartment positioned on the back side of the
cover, being sure that the battery compartment
is clean.
Insert 3× 1.5 V AAA alkaline batteries (not
included) in the battery compartment.
(Ensure correct polarity to avoid damaging
the timer).
8 bar (120 PSI)
3 °C–50 °C
(37 °F–122 °F)
IP 54
1/2/3/4 h...1 week
1/2/3/5...55 min
35 l/min
3× 1.5 V AAA battery
1 year aproximately
Insert new batteries
Check if:
The hose faucet is on.
Timer is set to ON
Clean the filter
(see fig. 2)
Close properly the battery compart and replace
the front cover, making sure correct position of
the cable to avoid compromising their integ-
rity and functionality of the unit control. After
power-on, all LED lights turn on for 1 second
and then go out.
After the light is off, follow-up operation can
be carried out.
TIMER INSTALLATION
Screw the sleeve nut from the water timer on
to the outdoor hose faucet and tighten firmly
to avoid leaks.
Watering time
• 1 min • 2 min • 3 min • 5 min • 8 min • 10 min
• 15 min • 20 min • 25 min • 30 min • 40 min
• 55 min
Watering frequency
• 1 Hour • 2 Hour • 3 Hour • 4 Hour • 5 Hour
• 6 Hour • 8 Hour • 12 Hour • 24 Hour • 48 Hour
• 72 Hour• 1 Week
SET WATERING DURATION
Press the setting button continuously, and the
LED for „ON" will light up. You can now select
the specified watering duration by repeatedly
pressing the „Setting" button. Wait 4 seconds
to confirm your setting.
3