EMAK MZ2060 Manual De Instrucciones página 23

ASSEMBLY OF THE REAR DRAWBAR
(Fig. 4)
- Position drawbar 3 in correspondence
with the central hole, then lock it with
the screw and the self-locking nut. The
drawbar can be adjusted in height.
- Unloosen screw 4, adjust and screw
back on (Fig. 4).
ASSEMBLY OF THE HANDLEBARS
Fig. 4
(Figs 5/A-5/B)
Fit handlebar 1 onto the Motorhoe
by means of the relative screws and
washers as shown in Fig. 5/a.
The handlebar may be adjusted in
height in three positions by unscrewing
lock knob 2 and positioning the screw
in another hole after having turned the
handlebar. Thereafter lock the knob.
On request, the handlebars can be
adjusted both in height and sideways
Fig. 5/A
with the possibility of locking them in the
wanted position.
For those models having such an
adjustment, this operation must be
carried forth with lever 3 (Fig. 5/b).
Make sure that lever 3 is always locked
after adjustment.
ASSEMBLY OF THE LEVERS
Fig. 5/B
(Fig. 5/C)
The forward and reverse throttle cables (if
applicable) are already connected to the
frame and fitted in their correspondent
levers.
Fit the levers in their respective seats on
the handlebars.
How to change the drive
(forward-reverse):
Fig. 5/C
- Pull control lever 4: forward gear
- Pull control lever 5: reverse gear
(Fig. 5/C).
21