BS Charger PB-02 Manual De Instrucciones página 5

CHARGING PROCESS
1 - Plug the USB cable to a charger with a USB output
2 - Plug the USB-C end of the cable to the input port of the Power Box start the charge.
Or
1 - Plug car adaptor to the car cigarette lighter socket.
2 - Plug the other end of the adapter to the input port of the Power Box to start the charge
STARTING THE VEHICLE
Emergency start function for gas or diesel vehicles equipped with a 12V battery.
To start a vehicle, please process as follows:
⚠
The Power Box must be at least 80% charged to make a start. A full charge of the booster is recommended.
1
2
3
4
5
6
7
CHARGING MOBILE PHONES
1 - Plug your cable to the Power Box USB port 1 or USB port 2 .
2 - Select the appropriate adaptor for your mobile phone or table and plug it in.
The Power Box launches the charge automatically.
| www.bs-battery.com
Connect the jumper cable to the Power Box connector .
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp to the (-) of the battery.
If the lights «Start» and «Error» flash alternately in green and red, the
product is ready.
If only the «Error» light is on, the internal battery of the Power Box is
too low. Charge the product.
If the «Start» light becomes green and the «Error» light turns off, everything is ok.
Make a start within 30 seconds.
⚠ Do not exceed 3 starts with a time interval of 30s between each.
After starting, disconnect the smart start cable from its connector and remove the 2
clamps from the vehicle's battery terminals within 30 seconds.
⚠ Leave the vehicle running.
If all 3 starts fail, check the «Error» light.
A red «Error» light on is synonymous with an engine or connection problem.
After the start-up, if the internal battery is less than 80%, recharge the Power Box.
⚠ Wait at least 30 minutes after starting the vehicle to charge the Power Box
POWER.
PB-02
5